Helical Head for PORTER-CABLE Variable Speed 6-inch Jointer PC160JT

Clean cut with no tear-out! The product comes with no instructions. While it's not difficult to install, half a page of instructions would have saved a bit of head-scratching time. As another reviewer states, the cutting head is slightly smaller diameter than the original, so you will have to modify your outfeed table by sanding down the standoffs ~1/32".

Piece of Cake

Installation was a piece of cake but.. The issue was aligning the outfeed table. With the PC 160 JT there is no adjustment for the outfeed table. To align it I had to sand some of the cast aluminum flat. Once that was done it set up easily and cuts smoothly and leaves a smooth finish. I am please with the results. I don't have a bearing puller so, I purchased the extra bearings just in case but I didn't need them. The old bearings came off the old cutter and on the new one very easily.