Miter Saw Station

Sliding mitre saw stand

Great plans and a good idea. Still in building phase but is looking good so far! Thanks very much

A blended miter saw station

I, too, have a small shop. So small that I had to use up some plywood before buying any new wood. But I liked the design you showed, so I bought Lincoln St Woodworks plan as well as yours and made a station with your measurements and sliding rails, but with my plywood. Now I have room for that fancy router bit you used!

Great Plans for the Build

Overall, the plans are great and easy to read. This is a great learning project for me as I have never created panels or made a table from boards before. Also, I don't have a dado stack since my table saw won't accept one, so I am doing it all with a router and table given to me by my wonderful neighbors, which is also a great learning experience. The only thing I have to point out is that there is a mistake (I think) in the measurements for the toe kick. It shows a 1/2 inch thickness for a 3/4 inch thick 1 x 4 board, and the width of the cut is too wide to get from a 1 x 4 board, so I think it should say it should be made from a 3/4 inch thick 1 x 6 board. Well, it fit for me and I made it with the measurements I thought it should be as opposed to the ones in the directions.