EIBOS Cold Build Plate KRIOS for Snapmaker U1 3D Printer

The adhesion on the plate is good. The rest of it is all bad. I ordered the plate for my Snapmaker U1, and the first thing I noticed is that the instruction pamphlet was stuck to the plate, leaving permanent residue when I peeled it off, leaving one side of the build plate unusable. To their credit, customer service did send me a new one immediately, but that one had the exact same issue. After the second, they told me to just use the plate as is. Fine, I guess I now have two half-plates that add up to a full plate technically. That's when I discovered that the plates aren't actually the right size for my U1. When the hot end purges at the back, it gouges the plate around it (yes, the plate is pushed back against the pegs as far as it will go). The plate material has good potential, but the logistics surrounding it were totally botched

I have had many a build plates in my day but this one is my new favorite. The only problem is that now I have to get one for all of my printers….

I would give zero stars if possible. The coating came off after one print.