CT4-V Blackwing Single Row LED Side Marker Lights

CT4 Blackwing Smoked/Amber Marker Lights

Huge improvement over the stock single LED and amber marker lights. Went for the smoked with amber LEDs and super happy with the way they look. Install was straight forward. Did it on the car on the ground and just turned the wheels to get access. Remove the size 15 Torq screws from the wheel liner behind the lights, make sure to get the 2-3 screws on the bottom so you dont damage the liner. There is a cover over the the screw to remove the light which is part of the fender, you will need to pull the corner of the bumper back to access the screw. To pull the bumper back, remove the 7mm (if I remember correctly) connecting the fender to the bumper behind the liner right above the marker light, carefully pop out the bumper from the fender, pull the bumper back just enough to get to the torx holding the light. I second Anthony's review and pre-thread the screws in the new lights before install. Then test and reverse install the bumper into the fender, the 7mm and torx screws. As a side note, I did these at the same time as installing the spec 2 splitter since it is easier to reinstall the bumper clips for the splitter through the fender liners I already had to take apart to install the new splitter if you are not trying to remove the front bumper for the splitter install.

Great easy mod

YouTube video shows how to install these side markers. Took about 30 minutes total to install both side markers, which are plug and play.

Great quality, easy install

Good quality lights. Easy install. I suggest pre threading the screw ahead of attaching to the bumper since the alignment was pretty tough without. Other than that, install was smooth