Mullet Mount

Installation was fairly easy and straightforward. I looked up the installation on Youtube which was clearer to view than the instructions included in the package. However a couple of the nuts seized up so I was unable to tighten or loosen the nuts. I had to cut the bolts off.

It looks great, but had issued during install. The Mount center support did not sit flat against the door skin bracket. Ended up cutting the rubber in half and shimming to get consistent contact. The elongated hole in the door skin bracket is not completely covered by the rubber gasket which will allow water to get behind the bracket. Will likely fill small opening with RTV sealant. The hole in the internal bracket was roughly 1" too high and needed to be redrilled. Its on and looks great, but don't think it needed to be this way.

Mount looks great. Had to use a chainsaw file to elongate bottom mount holes to get bolts to fit through hinge bracket and mount.