Micro Swiss NG™ Direct Drive Extruder for Creality CR-10 / Ender 3 Printers (Linear Rail Edition)

Amazing so far!

Still testing, but so far works great with foaming TPU. Does not come with brackets for BLtouch or CRtouch, so I had to fabricate it myself- no big deal. Just be aware of this if you use a probe for z. Also keep in mind the spacing for linear rails is 20mm and the 'official' creality linear rail is 15mm, so make sure you have the right style lineral rail carriage. Quality itself is top notch! I'm a sucker for nicely machined parts, and this looks incredible. Just wish the shroud was gone so I could admire the surface finish.

NG Linear Rail Extruder/Hot End

By installing this Extruder/Hot End I saved over 150g of weight over my old Hot end with a Satsana duct with the old Micro Swiss linear rail mounting plate and stock extruder stepper motor.. I'm trying to push my E3 v2 a little faster. This is my 3rd Micro Swiss extruder mount over the . First was one to use with rollers and transition to direct drive. The second with linear bearings. This one was mostly for the weight savings and the extruder can push more filament at higher volumes. So far I have reached 300mm/sec with good results. I did however print a duct assembly that uses a 5015 blower fan instead of the stock 4010 blower unit for better part cooling and am using a solid copper heat block. All of the Micro Swiss extruders are top notch.

Great device

I'm very satisfy of this device, all works fine, both for installation and for use. No surprise.