TONGUE & GROOVE WITH V SHAPER CUTTERS

Good for thick stock

These are the only set on the market I have found for T & G paneling that will work with anything one inch or well above... I have not tried it yet on 1 1/2 " stock yet but can clearly see it will work with stock well beyond a inch thick .. You will find T & G V joint paneling cutters that claim up to one inch do not clear out the full one inch below the cut leaving a stub on the bottom side... You can avoid that by lowering the spindle but now you cut to deep in the top side and your Tongue and groove is not center placed where it should be.. Maybe to explain further...Your trying to line up butt cuts for matching T & G paneling [matching meaning Tongue and grooved all 4 sides] You have a 4 sided molder already T amd G the sides and now you want to match the butt ends .. I work with THICK stock... So my paneling is not 3/4" but one inch thick...... You will not find another cutter for inch PLUS thick stock to make matching butt ends ..The ones that do up to one inch will leave a stub if you want a nice centered tongue or groove on your V paneling....The 4 stars only because I would prefer the tongue to be slightly thicker as its a slight buit thin...

This worked great on my Grizzly

This bolted right into my Grizzly shaper and churned out some nice results. Ran one in one direction and the other in reverse. Am thinking of new projects to use them on. Very good product.

Impressed !

My experience was great !!