High Flow ObXidian® HotEnd for Bambu Lab A1, A1 Mini & A2L

High flow obxidian .4mm

High flow obxidian hot ends work very well. Now even better bambu have up dated their soft wear for them . Thanks guys

Print quality and speed has gone through the roof!! Higly recommended upgrade!

Simply Awesome

I wasn't sure I would be into 3d printing in short it's been an amazing training experience in patience. These Hot Ends are next level though. Applying the premade print profiles from makerwold to my prints has saved dozens of hours. I haven't used the 0.6mm hot end yet but for the 0.4 I can see between 1 minute on short prints and 2 hours on long prints saved when I swap back and forth between profiles when slicing. Nomillay I would say about a half hour. But on long prints eg 10-12 hours it normally saves me an hour or two due to the higher extrusion rate. .45mm vs .20mm