BIQU HT-NTC100K Thermistor for 3D Printers – 350°C High-Temperature Sensor with 1M/2M Cable

How do I hook this to the H2 Lite?

I bought this with the H2 Lite on your recommendation, but there is no obvious way to attach it to the H2 Lite. Am I to put it along side the hot end and wrap it in Kapton tape? And advise would be great! It should be a decent upgrade.

Good thermistor for those bigger machines

I’ve been building a printer with a 410x410x450mm build volume and the Biqu H2 extruder setup and needed longer leads than usual. These fit the bill and left me about 50mm of extra wire. Temperature measurement is very accurate and it doesn’t seem to fluctuate any. The wires are very rugged so it should last a very long time.