Whole milled angled (fillet) clamps Hapstone R2

I was finally able to clamp my filet knife into my Jende JIGS via a GEARCONNECT adaptor. The original adaptors broke quickly. They have a few fundamental design issues that affect their longevity. The second photo is my attempt to address one of those problems. I inserted a number of steel washers into the interface between the adaptor and your clamp in order to disperse torquing stress away from the plastic and onto the washers and R2 clamp interface. Cross your fingers. In any event I successfully clamped and sharpened the filet knife to the factory 15 degrees.

Because I use 9 degree angle on my chef knives these new clamps make it much easier.

Perfect for thinner edge angle.