Swingarm Protection Graphics

swingarm guards

Hello, I did a little review earlier on my new swingarm guards. Tonight, when looking at the bike, I noticed one of the zip ties on the right hand side had broken. I had only done a street ride since the install. I have had all of my spare zip ties that I ordered from you, now break. I believe the design on the right hand side of my 2026 Beta 300 RR Race, may have changed since you made these guards. I would be happy to send you some photos. There is a gap, almost 1/2" on the front of the guard. The zip ties also go through the guard at a slight angle, due to the rounded inner section of the swingarm, where the zip tie goes through the swingarm, same area that the rear shock goes through. Without a zip tie, when just lining up the guard on the swingarm, it does not press all the way onto the swingarm, leaving that 1/2 inch gap on the front face section. Could you at least send me some more zip ties? I used some foam rubber to fill the void, and now just not tightening the zip tie very much, due to the angles fighting and not permitting a super snug pull on the zip tie. I believe the guard needs to be modified in order to really fit nice. Please feel free to email me if you want some photos.

Not exact fit

There are cutouts for the casting marks but they’re not correct. When I contacted crosslinked they said “Looks like the casting marks moved, you should try using a heat gun” which I had already done. This left the swingarms with extra areas that are unprotected and some areas that are wrinkled over. Would’ve been better to not have any cutouts and let the customer do it manually.

Best protection around

I have run cc on my last 3 bikes. Top notch quality and even better customer service.