PVP/VA Bed adhesion powder

I have tried numerous bed adhesives, but none was ever as effective or with consistent results, and many were messy. Since using liquid Ghetto Goop I have not had to use any other bed adhesive. I have changed from the liquid Ghetto Goop to the powder version and have continued to have excellent results. Easy to apply, works perfectly and no mess to clean up. I have also found I do not have to wash my print plates - they stay clean without any adhesive build up. The powder Ghetto Goop is cost effective, and I apply it using a 100ml hand pump spray bottle and then spread it over the plate using a small flat 7mm wide paint brush.

As a newbie using secondhand Ender3 printers I'm learning as I go. This PVP/VA powder has been fantastic & I haven't had a failure due to poor bed adhesion since starting to use this & as a bonus it washes off so easily. I use the Ghetto Goop as an application tool as I find it easier to spread the solution that I spray on. I sometimes add an extra layer if I think the previous print took up a large area on the build plate.

Highly recommended for PC prints

I got this as I was having issues with 1st layer adhesion with PC. Filament was dried, used gluesticks, nothing worked. Sides were lifting, stringiness here and there. Gave this a mix with IPA and water and I'll let the results speak for itself. A must have for PC for me.