35MM Rise Side Mount Adjustable Angle Clipon Risers for Yamaha R7

35 mm risers R7 specific

I like the bars, and the 35mm is a significant change. The video on youtube for instructions was pretty weak, I listened to the guy for a few minutes (watch the video, you'll understand. sniff sniff) then decided I could figure it out just as well. When I ordered these, I was looking at two different kits. The Woodcraft didn't say anything about rerouting throttle cables, so I went with them. I had two stumbling blocks, one the clutch side, the perch hits the riser with the bushing at the seven degree up, I pushed it out further past my mark and it is doable, however at max right the pod hits the fairing. Not a huge deal, but annoying. On the throttle side, there is very little room after installation for your cables. I understand the new height takes away the stock cable slack, however, I had to re route the cables and cut the bracket to get just enough room. It is almost too tight at full right deflection, but with the throttle tube, pod, and front brake perch squeezed tightly together, it does work. It's fairly straightforward, however, without printed instructions and parts marked L/R, it takes a little bit to set it up.