DevSport Side Skirt Splitters (2000-2009 Honda S2000)

After searching for the perfect side skirt came up empty I came across Devsports side splitters. This was the look I wanted the entire time! The install was simple with provided hardware including a few spares and I didn’t even need a lift. 2 person install made it super easy but I could have installed alone if absolutely had to. If you buy the winglets install those to the splitter first, then place splitter up to the pinch weld and mark at least 2 holes to drill small pilot holes. From there I started the screws with a drill then hand tightened to make sure not to strip out the screws. 1 of the holes you’ll notice doesn’t drill deep enough so you’ll need to make sure the pilot hole is all the way through before starting the screw. Make sure to test fit and check your factory plastic fender liner or side strakes locations before marking your pilot holes! We test fit a few times before realizing we needed to slightly trim a piece of the plastic edge of the fender liner that touches the pinch weld in order to get flush to that weld with the strakes. Install was maybe a 4 out of 10 for difficulty based on needing 2 people and some minor adjustment to get to sit against the pinch weld but any DIY enthusiast can install. DO NOT TIGHTEN ALL THE WAY WITH AN INPACT OR DRILL, you can strip the screws out if you don’t pay attention.

Arrived really well packaged and secured. Clear indicators on the exterior to be careful and do not bend. Arrived quickly. Very please with this vendor.

Packaged up great. Fitment and Installation was a snap and looks awesome.