XTR Flexi Plate - 225 x 129

The installation process for this is easy except for the adjustment for the printer which the link should be updated for that. As for actually using it it's great. Just flex it around a bit and some stuff just falls off or you can slide it off. After scuffing the surface as the instructions say I have had no issues with print adhesion. I definitely advise using this over the regular build plate and having to scrape it off and having things go flying sometimes. I can use the soft plastic scraper to remove the prints that don't want to just fall off.

Maybe not worth the trouble

The wham bam plate and magnet are very good quality and strong, but present some drawbacks. They take up a lot of volume in your resin vat, so you have to refill more frequently. They are another few surfaces that need to be cleaned every cycle. And pulling the plate of the magnet tends to "spring" and launch bits of resin all over your room. If your prints are too small and don't pop off the plate, it's more difficult to hold onto when scraping the prints off. It’s tricky to line the plate up with the magnet for new prints, and the plate doesn't always sit flat against the magnet, leading to adherence issues & print failures the next cycle. So, consider the draw backs before buying.

Need to buy the magnet as well!

It is not clear or obvious on the website that you need to buy the magnet as well, so I have no idea how well it works. I would be willing to change this review if they rectify this.