Worker Seagull Springs

this scares me very nice and good

Oh yeah punch.

Wasn't sure how much punch it was going to add, but im glad I did. I bought it for the Taisan the metal version of the Seagull, I'm super pumped i did.

New ood specs are a little off

Grabbed the ood 1.57, 1.65, and 1.7 springs, but the inner diameter on them seems to be a tad tight. The 1.57 slid onto the worker plunger fine, but the 1.65 and 1.7 both had the squared coil fit snug on the plunger's tail. The problem is the plunger has a wider diameter section at the base of its tail to secure springs, so the squared ends of the 1.65 and 1.7 springs don't seat fully into the plunger. I used a slim spacer on the plunger head to fill that space, and ran some shots through a harrier. 250, 270, and 290 average respectively with a 31cm barrel. The 1.7 was a bit much to finish the prime. Neglected to put them through my seagull because of the plunger issue and the older ood piano wire 1.6 spring (the new ones are stainless steel or zinc plated) already working well for 200 with a mildly challenging prime.