Bafang ES-Bus 1T4 Cable

Broken wires at the splitter killed my display and controller

The one I am referring to here is for converting a Tongsheng motor tor to Bafang display and components. My first one of these a couple of wires broke in side where the cable flexed where I had a wire tie just before the large splitter. I suggest wire tying over the hard splitter not the wire. Also my first one came with a same gender 8pin connector as the motor meaning I had to replace both connectors with DEUTSCH connectors. The replacement T1-4 was totally different and had the proper gendered connector. Also on the first one when I replaced the connector I found most of the wires were not going to the correct pins.